Bose Backpocket Knife Construction/34backpocketconst.jpg Previous | Home | Next

Preparing to countersink the bolster's pivot pin hole. A 10 degree reamer is used to a depth of about .040". Tony says "...any more than that and you're asking the pin material to do too much to fill the space." The goal is to spread the pin out into the bolster so that there is no visible joint between them.

© Copyright 2007 - 2010 BoseKnives.com. All rights reserved.
Content may be reproduced for personal use only.
Please report problems with this page and associated links to Webmaster