Bose Backpocket Knife Construction/41backpocketconst.jpgPrevious | Home | Next |
The handle material is dry fitted to the bolster prior to drilling. When he is
satisfied with the fit, he will clamp and drill the pin holes. With the holes
drilled, he temporarily pins the handle to the liner assembly and rechecks the
fit with a loop. If that is good, he uses gap filling super glue in spots on
the handle material and uses the extra long pin to guide the handle into place.
I didn't get any pictures of that so you'll have to use your imagination for
now. |
© Copyright 2007 - 2010 BoseKnives.com.
All rights reserved.
Content may be reproduced for personal use only.
Please report problems with this page and associated links to Webmaster