Bose Backpocket Knife Construction/6backpocketconst.jpgPrevious | Home | Next |
Soldering the liner/bolster assembly. Notice the pin in the pivot hole which
helps to align the parts. Tony is heating the bolster side of the assembly while
watching for the solder to begin "flowing" onto the liner. Make sure
not to overheat
and stop just as the solder becomes "wet" |
© Copyright 2007 - 2010 BoseKnives.com.
All rights reserved.
Content may be reproduced for personal use only.
Please report problems with this page and associated links to Webmaster